This is a two-piece polycarbonate plastic enclosure specifically for Odroid-XU4 board.
To install, place the Odroid-XU4 board on the base part of the case and screw it with two screws. Then, put the second piece on top and put the two screws from the bottom of the case to secure the pieces together.
The case has openings for Ethernet port, USB ports, DC power jack, HDMI and micro SD card at the bottom. GPIO pins are covered, but if necessary, you have to remove the top cover for easy access to GPIO pins.
There are ample ventilation openings at the top and bottom of the case for better heat management.
This case supports both the Odroid-XU4 with active fan cooler or the Odroid-XU4Q with passive heatsink. To fit the tall heatsink on the Odroid-XU4Q, you need to cut a few ribs on the top part of the case to make a square hole.
