This is an economical two-piece injection moulded case for your Raspberry Pi 4 Model B. It is a simple case is made of top and bottom parts that press-fit together and the smooth rounded corners give a minimalist look to the case.
To use the case, secure the board to the base of the case with four screws. Snap on the case top to give protection to your Pi. If you want to poke around, the top can be detached easily. The top cover has openings for cooling fan, DSI and CSI. The GPIO pins are covered but if you want an easy access to the pins, you can cut the tabs to remove the cover. The base has ventilation openings and mounting slots that you can use to mount the case vertically to a wall for example. Four non-slip rubber feet are included that you can attach to the outer part of the base.
For a better heat management, a mini cooling fan is included. It can be mounted to the top cover on the inner part of the case with still some room available for you to attach a heatsink to the main chip. Another option is to mount the fan on the outside of the top cover. Then you have more room should you want to utilize a bigger heatsink. The fan has a 2-pin connector to be attached to the 5V and Ground pin.
This case is for Raspberry Pi 4 Model B. Click here if you are looking for a similar case for Raspberry Pi 3 B, 2 B, B+ or ASUS Tinker Board.
*Raspberry Pi Board is not included
Features:
Two-piece construction, base and top, moulded in a smooth finish ABS plastic
Four screws holding the board into position allowing it to be operated with or without the cover in place
A mini cooling fan (30x30 mm) can be mounted to the top cover
Top cover can be easily removed without the need to unplug any cables
Top cover has openings for DSI, CSI and GPIO cabling/wiring
The base has two screw slots to allow the enclosure to be vertically mounted
Vented base to allow through air flow
Mini cooling fan, mounting screws and nuts and four non-slip rubber feet are included
