The case is made of 2-piece frosted ABS plastics which provides adequate protection for your Pi and access to all the ports. A mini cooling fan can be mounted inside the case for a good thermal management.
The case has slots at the sides so that you can route GPIO and CSI ribbon cable. At the back of the case, there are two mounting holes, 4 anti-slip rubber feet and a cut-out to facilitate the micro SD card insertion and removal. This case is also designed so that you can see the Pi status LEDs clearly.
The mini cooling fan
This fan is mounted with 2 screws on the inside of the top panel. The position is direct above the main chip which is one of the most significant heat source from the Pi. With the fan mounted, there is still some space to attach a heatsink on the chip for better heat dissipation.
The fan requires 5V DC and you can power it up with the Pi's power header. There is a connector with two wires, red and black attached to the fan. The red wire is for 5V DC and you need to connect it to the pin number 4 and the black wire is for ground, to be connected to the pin number 6. For a clearer picture, please refer to the gallery.
This case is compatible with the Raspberry Pi 3 Model B.
Features:
2-piece frosted ABS case with a mini cooling fan mounted inside
All ports are accessible
Slots to route GPIO and CSI ribbon cable
Cut-out for micro SC card at the bottom panel
Mounting holes and anti-slip rubber feet at the back
